| TPO TPG110 Panel |
| ================ |
| |
| This binding builds on the DPI bindings, adding a few properties |
| as a superset of a DPI. See panel-dpi.txt for the required DPI |
| bindings. |
| |
| Required properties: |
| - compatible : "tpo,tpg110" |
| - grestb-gpios : panel reset GPIO |
| - scen-gpios : serial control enable GPIO |
| - scl-gpios : serial control clock line GPIO |
| - sda-gpios : serial control data line GPIO |
| |
| Required nodes: |
| - Video port for DPI input, see panel-dpi.txt |
| - Panel timing for DPI setup, see panel-dpi.txt |
| |
| Example |
| ------- |
| |
| panel { |
| compatible = "tpo,tpg110", "panel-dpi"; |
| grestb-gpios = <&stmpe_gpio44 5 GPIO_ACTIVE_LOW>; |
| scen-gpios = <&gpio0 6 GPIO_ACTIVE_LOW>; |
| scl-gpios = <&gpio0 5 GPIO_ACTIVE_HIGH>; |
| sda-gpios = <&gpio0 4 GPIO_ACTIVE_HIGH>; |
| backlight = <&bl>; |
| |
| port { |
| nomadik_clcd_panel: endpoint { |
| remote-endpoint = <&nomadik_clcd_pads>; |
| }; |
| }; |
| |
| panel-timing { |
| clock-frequency = <33200000>; |
| hactive = <800>; |
| hback-porch = <216>; |
| hfront-porch = <40>; |
| hsync-len = <1>; |
| vactive = <480>; |
| vback-porch = <35>; |
| vfront-porch = <10>; |
| vsync-len = <1>; |
| }; |
| }; |
