| Raydium RM67171 OLED LCD panel with MIPI-DSI protocol |
| |
| Required properties: |
| - compatible: "raydium,rm67191" |
| - reg: virtual channel for MIPI-DSI protocol |
| must be <0> |
| - dsi-lanes: number of DSI lanes to be used |
| must be <3> or <4> |
| - port: input port node with endpoint definition as |
| defined in Documentation/devicetree/bindings/graph.txt; |
| the input port should be connected to a MIPI-DSI device |
| driver |
| |
| Optional properties: |
| - reset-gpios: a GPIO spec for the RST_B GPIO pin |
| - v3p3-supply: phandle to 3.3V regulator that powers the VDD_3V3 pin |
| - v1p8-supply: phandle to 1.8V regulator that powers the VDD_1V8 pin |
| - width-mm: see panel-common.txt |
| - height-mm: see panel-common.txt |
| - video-mode: 0 - burst-mode |
| 1 - non-burst with sync event |
| 2 - non-burst with sync pulse |
| |
| Example: |
| |
| panel@0 { |
| compatible = "raydium,rm67191"; |
| reg = <0>; |
| pinctrl-0 = <&pinctrl_mipi_dsi_0_1_en>; |
| pinctrl-names = "default"; |
| reset-gpios = <&gpio1 7 GPIO_ACTIVE_LOW>; |
| dsi-lanes = <4>; |
| width-mm = <68>; |
| height-mm = <121>; |
| |
| port { |
| panel_in: endpoint { |
| remote-endpoint = <&mipi_out>; |
| }; |
| }; |
| }; |
