blob: ce3df2fff6c8816a277a316b940ea6549c34c7e5 [file] [log] [blame]
* I2C controller embedded in STMicroelectronics STM32 I2C platform
Required properties:
- compatible: Must be one of the following
- "st,stm32f4-i2c"
- "st,stm32f7-i2c"
- reg: Offset and length of the register set for the device
- interrupts: Must contain the interrupt id for I2C event and then the
interrupt id for I2C error.
- resets: Must contain the phandle to the reset controller.
- clocks: Must contain the input clock of the I2C instance.
- A pinctrl state named "default" must be defined to set pins in mode of
operation for I2C transfer
- #address-cells = <1>;
- #size-cells = <0>;
Optional properties:
- clock-frequency: Desired I2C bus clock frequency in Hz. If not specified,
the default 100 kHz frequency will be used.
For STM32F4 SoC Standard-mode and Fast-mode are supported, possible values are
100000 and 400000.
For STM32F7, STM32H7 and STM32MP1 SoCs, Standard-mode, Fast-mode and Fast-mode
Plus are supported, possible values are 100000, 400000 and 1000000.
- dmas: List of phandles to rx and tx DMA channels. Refer to stm32-dma.txt.
- dma-names: List of dma names. Valid names are: "rx" and "tx".
- i2c-scl-rising-time-ns: I2C SCL Rising time for the board (default: 25)
For STM32F7, STM32H7 and STM32MP1 only.
- i2c-scl-falling-time-ns: I2C SCL Falling time for the board (default: 10)
For STM32F7, STM32H7 and STM32MP1 only.
I2C Timings are derived from these 2 values
- st,syscfg-fmp: Use to set Fast Mode Plus bit within SYSCFG when Fast Mode
Plus speed is selected by slave.
1st cell: phandle to syscfg
2nd cell: register offset within SYSCFG
3rd cell: register bitmask for FMP bit
For STM32F7, STM32H7 and STM32MP1 only.
Example:
i2c@40005400 {
compatible = "st,stm32f4-i2c";
#address-cells = <1>;
#size-cells = <0>;
reg = <0x40005400 0x400>;
interrupts = <31>,
<32>;
resets = <&rcc 277>;
clocks = <&rcc 0 149>;
pinctrl-0 = <&i2c1_sda_pin>, <&i2c1_scl_pin>;
pinctrl-names = "default";
};
i2c@40005400 {
compatible = "st,stm32f7-i2c";
#address-cells = <1>;
#size-cells = <0>;
reg = <0x40005400 0x400>;
interrupts = <31>,
<32>;
resets = <&rcc STM32F7_APB1_RESET(I2C1)>;
clocks = <&rcc 1 CLK_I2C1>;
pinctrl-0 = <&i2c1_sda_pin>, <&i2c1_scl_pin>;
pinctrl-names = "default";
st,syscfg-fmp = <&syscfg 0x4 0x1>;
};