| * Sony 1/3.06-Inch 13.13Mp CMOS Digital Image Sensor |
| |
| The Sony imx214 is a 1/3.06-inch CMOS active pixel digital image sensor with |
| an active array size of 4224H x 3200V. It is programmable through an I2C |
| interface. |
| Image data is sent through MIPI CSI-2, through 2 or 4 lanes at a maximum |
| throughput of 1.2Gbps/lane. |
| |
| |
| Required Properties: |
| - compatible: Shall be "sony,imx214". |
| - reg: I2C bus address of the device. Depending on how the sensor is wired, |
| it shall be <0x10> or <0x1a>; |
| - enable-gpios: GPIO descriptor for the enable pin. |
| - vdddo-supply: Chip digital IO regulator (1.8V). |
| - vdda-supply: Chip analog regulator (2.7V). |
| - vddd-supply: Chip digital core regulator (1.12V). |
| - clocks: Reference to the xclk clock. |
| - clock-frequency: Frequency of the xclk clock. |
| |
| Optional Properties: |
| - flash-leds: See ../video-interfaces.txt |
| - lens-focus: See ../video-interfaces.txt |
| |
| The imx214 device node shall contain one 'port' child node with |
| an 'endpoint' subnode. For further reading on port node refer to |
| Documentation/devicetree/bindings/media/video-interfaces.txt. |
| |
| Required Properties on endpoint: |
| - data-lanes: check ../video-interfaces.txt |
| - link-frequencies: check ../video-interfaces.txt |
| - remote-endpoint: check ../video-interfaces.txt |
| |
| Example: |
| |
| camera-sensor@1a { |
| compatible = "sony,imx214"; |
| reg = <0x1a>; |
| vdddo-supply = <&pm8994_lvs1>; |
| vddd-supply = <&camera_vddd_1v12>; |
| vdda-supply = <&pm8994_l17>; |
| lens-focus = <&ad5820>; |
| enable-gpios = <&msmgpio 25 GPIO_ACTIVE_HIGH>; |
| clocks = <&mmcc CAMSS_MCLK0_CLK>; |
| clock-frequency = <24000000>; |
| port { |
| imx214_ep: endpoint { |
| data-lanes = <1 2 3 4>; |
| link-frequencies = /bits/ 64 <480000000>; |
| remote-endpoint = <&csiphy0_ep>; |
| }; |
| }; |
| }; |
