blob: f522bb8e47e1c7dc39dd7e8e21d6387bbc492df2 [file] [log] [blame]
Sharp Microelectronics 10.1" WQXGA TFT LCD panel
This panel requires a dual-channel DSI host to operate. It supports two modes:
- left-right: each channel drives the left or right half of the screen
- even-odd: each channel drives the even or odd lines of the screen
Each of the DSI channels controls a separate DSI peripheral. The peripheral
driven by the first link (DSI-LINK1), left or even, is considered the primary
peripheral and controls the device. The 'link2' property contains a phandle
to the peripheral driven by the second link (DSI-LINK2, right or odd).
Note that in video mode the DSI-LINK1 interface always provides the left/even
pixels and DSI-LINK2 always provides the right/odd pixels. In command mode it
is possible to program either link to drive the left/even or right/odd pixels
but for the sake of consistency this binding assumes that the same assignment
is chosen as for video mode.
Required properties:
- compatible: should be "sharp,lq101r1sx01"
- reg: DSI virtual channel of the peripheral
Required properties (for DSI-LINK1 only):
- link2: phandle to the DSI peripheral on the secondary link. Note that the
presence of this property marks the containing node as DSI-LINK1.
- power-supply: phandle of the regulator that provides the supply voltage
Optional properties (for DSI-LINK1 only):
- backlight: phandle of the backlight device attached to the panel
Example:
dsi@54300000 {
panel: panel@0 {
compatible = "sharp,lq101r1sx01";
reg = <0>;
link2 = <&secondary>;
power-supply = <...>;
backlight = <...>;
};
};
dsi@54400000 {
secondary: panel@0 {
compatible = "sharp,lq101r1sx01";
reg = <0>;
};
};