blob: 249790a93017571da5cf3f9366737f8a5a5f7a49 [file] [log] [blame]
STMicroelectronics STM32 Digital Camera Memory Interface (DCMI)
Required properties:
- compatible: "st,stm32-dcmi"
- reg: physical base address and length of the registers set for the device
- interrupts: should contain IRQ line for the DCMI
- resets: reference to a reset controller,
see Documentation/devicetree/bindings/reset/st,stm32-rcc.txt
- clocks: list of clock specifiers, corresponding to entries in
the clock-names property
- clock-names: must contain "mclk", which is the DCMI peripherial clock
- pinctrl: the pincontrol settings to configure muxing properly
for pins that connect to DCMI device.
See Documentation/devicetree/bindings/pinctrl/st,stm32-pinctrl.txt.
- dmas: phandle to DMA controller node,
see Documentation/devicetree/bindings/dma/stm32-dma.txt
- dma-names: must contain "tx", which is the transmit channel from DCMI to DMA
DCMI supports a single port node with parallel bus. It should contain one
'port' child node with child 'endpoint' node. Please refer to the bindings
defined in Documentation/devicetree/bindings/media/video-interfaces.txt.
Example:
dcmi: dcmi@50050000 {
compatible = "st,stm32-dcmi";
reg = <0x50050000 0x400>;
interrupts = <78>;
resets = <&rcc STM32F4_AHB2_RESET(DCMI)>;
clocks = <&rcc 0 STM32F4_AHB2_CLOCK(DCMI)>;
clock-names = "mclk";
pinctrl-names = "default";
pinctrl-0 = <&dcmi_pins>;
dmas = <&dma2 1 1 0x414 0x3>;
dma-names = "tx";
port {
dcmi_0: endpoint {
remote-endpoint = <...>;
bus-width = <8>;
hsync-active = <0>;
vsync-active = <0>;
pclk-sample = <1>;
};
};
};