blob: ddd18c1351486d579606123aa900683848c29e65 [file] [log] [blame]
* STMicroelectronics Quad Serial Peripheral Interface(QuadSPI)
Required properties:
- compatible: should be "st,stm32f469-qspi"
- reg: the first contains the register location and length.
the second contains the memory mapping address and length
- reg-names: should contain the reg names "qspi" "qspi_mm"
- interrupts: should contain the interrupt for the device
- clocks: the phandle of the clock needed by the QSPI controller
- A pinctrl must be defined to set pins in mode of operation for QSPI transfer
Optional properties:
- resets: must contain the phandle to the reset controller.
A spi flash must be a child of the nor_flash node and could have some
properties. Also see jedec,spi-nor.txt.
Required properties:
- reg: chip-Select number (QSPI controller may connect 2 nor flashes)
- spi-max-frequency: max frequency of spi bus
Optional property:
- spi-rx-bus-width: see ../spi/spi-bus.txt for the description
Example:
qspi: spi@a0001000 {
compatible = "st,stm32f469-qspi";
reg = <0xa0001000 0x1000>, <0x90000000 0x10000000>;
reg-names = "qspi", "qspi_mm";
interrupts = <91>;
resets = <&rcc STM32F4_AHB3_RESET(QSPI)>;
clocks = <&rcc 0 STM32F4_AHB3_CLOCK(QSPI)>;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_qspi0>;
flash@0 {
reg = <0>;
spi-rx-bus-width = <4>;
spi-max-frequency = <108000000>;
...
};
};