#!/bin/sh
# SPDX-License-Identifier: GPL-2.0-only

pe_ok() {
	local dev="$1"
	local path="/sys/bus/pci/devices/$dev/eeh_pe_state"

	if ! [ -e "$path" ] ; then
		return 1;
	fi

	local fw_state="$(cut -d' ' -f1 < $path)"
	local sw_state="$(cut -d' ' -f2 < $path)"

	# If EEH_PE_ISOLATED or EEH_PE_RECOVERING are set then the PE is in an
	# error state or being recovered. Either way, not ok.
	if [ "$((sw_state & 0x3))" -ne 0 ] ; then
		return 1
	fi

	# A functioning PE should have the EEH_STATE_MMIO_ACTIVE and
	# EEH_STATE_DMA_ACTIVE flags set. For some goddamn stupid reason
	# the platform backends set these when the PE is in reset. The
	# RECOVERING check above should stop any false positives though.
	if [ "$((fw_state & 0x18))" -ne "$((0x18))" ] ; then
		return 1
	fi

	return 0;
}

eeh_supported() {
	test -e /proc/powerpc/eeh && \
	grep -q 'EEH Subsystem is enabled' /proc/powerpc/eeh
}

eeh_one_dev() {
	local dev="$1"

	# Using this function from the command line is sometimes useful for
	# testing so check that the argument is a well-formed sysfs device
	# name.
	if ! test -e /sys/bus/pci/devices/$dev/ ; then
		echo "Error: '$dev' must be a sysfs device name (DDDD:BB:DD.F)"
		return 1;
	fi

	# Break it
	echo $dev >/sys/kernel/debug/powerpc/eeh_dev_break

	# Force an EEH device check. If the kernel has already
	# noticed the EEH (due to a driver poll or whatever), this
	# is a no-op.
	echo $dev >/sys/kernel/debug/powerpc/eeh_dev_check

	# Enforce a 30s timeout for recovery. Even the IPR, which is infamously
	# slow to reset, should recover within 30s.
	max_wait=30

	for i in `seq 0 ${max_wait}` ; do
		if pe_ok $dev ; then
			break;
		fi
		echo "$dev, waited $i/${max_wait}"
		sleep 1
	done

	if ! pe_ok $dev ; then
		echo "$dev, Failed to recover!"
		return 1;
	fi

	echo "$dev, Recovered after $i seconds"
	return 0;
}