| Sharp 15" LQ150X1LG11 XGA TFT LCD panel |
| |
| Required properties: |
| - compatible: should be "sharp,lq150x1lg11" |
| - power-supply: regulator to provide the VCC supply voltage (3.3 volts) |
| |
| Optional properties: |
| - backlight: phandle of the backlight device |
| - rlud-gpios: a single GPIO for the RL/UD (rotate 180 degrees) pin. |
| - sellvds-gpios: a single GPIO for the SELLVDS pin. |
| |
| If rlud-gpios and/or sellvds-gpios are not specified, the RL/UD and/or SELLVDS |
| pins are assumed to be handled appropriately by the hardware. |
| |
| Example: |
| |
| backlight: backlight { |
| compatible = "pwm-backlight"; |
| pwms = <&pwm 0 100000>; /* VBR */ |
| |
| brightness-levels = <0 20 40 60 80 100>; |
| default-brightness-level = <2>; |
| |
| power-supply = <&vdd_12v_reg>; /* VDD */ |
| enable-gpios = <&gpio 42 GPIO_ACTIVE_HIGH>; /* XSTABY */ |
| }; |
| |
| panel { |
| compatible = "sharp,lq150x1lg11"; |
| |
| power-supply = <&vcc_3v3_reg>; /* VCC */ |
| |
| backlight = <&backlight>; |
| rlud-gpios = <&gpio 17 GPIO_ACTIVE_HIGH>; /* RL/UD */ |
| sellvds-gpios = <&gpio 18 GPIO_ACTIVE_HIGH>; /* SELLVDS */ |
| }; |
