blob: adc94fc3c9f88543862821bbc0ac6f506f6cfc1c [file] [log] [blame]
Rockchip DWC HDMI TX Encoder
============================
The HDMI transmitter is a Synopsys DesignWare HDMI 1.4 TX controller IP
with a companion PHY IP.
These DT bindings follow the Synopsys DWC HDMI TX bindings defined in
Documentation/devicetree/bindings/display/bridge/dw_hdmi.txt with the
following device-specific properties.
Required properties:
- compatible: should be one of the following:
"rockchip,rk3288-dw-hdmi"
"rockchip,rk3399-dw-hdmi"
- reg: See dw_hdmi.txt.
- reg-io-width: See dw_hdmi.txt. Shall be 4.
- interrupts: HDMI interrupt number
- clocks: See dw_hdmi.txt.
- clock-names: Shall contain "iahb" and "isfr" as defined in dw_hdmi.txt.
- ports: See dw_hdmi.txt. The DWC HDMI shall have a single port numbered 0
corresponding to the video input of the controller. The port shall have two
endpoints, numbered 0 and 1, connected respectively to the vopb and vopl.
- rockchip,grf: Shall reference the GRF to mux vopl/vopb.
Optional properties
- ddc-i2c-bus: The HDMI DDC bus can be connected to either a system I2C master
or the functionally-reduced I2C master contained in the DWC HDMI. When
connected to a system I2C master this property contains a phandle to that
I2C master controller.
- clock-names: See dw_hdmi.txt. The "cec" clock is optional.
- clock-names: May contain "cec" as defined in dw_hdmi.txt.
- clock-names: May contain "grf", power for grf io.
- clock-names: May contain "vpll", external clock for some hdmi phy.
Example:
hdmi: hdmi@ff980000 {
compatible = "rockchip,rk3288-dw-hdmi";
reg = <0xff980000 0x20000>;
reg-io-width = <4>;
ddc-i2c-bus = <&i2c5>;
rockchip,grf = <&grf>;
interrupts = <GIC_SPI 103 IRQ_TYPE_LEVEL_HIGH>;
clocks = <&cru PCLK_HDMI_CTRL>, <&cru SCLK_HDMI_HDCP>;
clock-names = "iahb", "isfr";
ports {
hdmi_in: port {
#address-cells = <1>;
#size-cells = <0>;
hdmi_in_vopb: endpoint@0 {
reg = <0>;
remote-endpoint = <&vopb_out_hdmi>;
};
hdmi_in_vopl: endpoint@1 {
reg = <1>;
remote-endpoint = <&vopl_out_hdmi>;
};
};
};
};