blob: ba1934b950e5d04ad8822b6e27c02a3a8c52a3da [file] [log] [blame]
* Texas Instruments TRF7970A RFID/NFC/15693 Transceiver
Required properties:
- compatible: Should be "ti,trf7970a".
- spi-max-frequency: Maximum SPI frequency (<= 2000000).
- interrupts: A single interrupt specifier.
- ti,enable-gpios: One or two GPIO entries used for 'EN' and 'EN2' pins on the
TRF7970A. EN2 is optional.
- vin-supply: Regulator for supply voltage to VIN pin
Optional SoC Specific Properties:
- pinctrl-names: Contains only one value - "default".
- pintctrl-0: Specifies the pin control groups used for this controller.
- autosuspend-delay: Specify autosuspend delay in milliseconds.
- irq-status-read-quirk: Specify that the trf7970a being used has the
"IRQ Status Read" erratum.
- en2-rf-quirk: Specify that the trf7970a being used has the "EN2 RF"
erratum.
- vdd-io-supply: Regulator specifying voltage for vdd-io
- clock-frequency: Set to specify that the input frequency to the trf7970a is 13560000Hz or 27120000Hz
Example (for ARM-based BeagleBone with TRF7970A on SPI1):
&spi1 {
nfc@0 {
compatible = "ti,trf7970a";
reg = <0>;
pinctrl-names = "default";
pinctrl-0 = <&trf7970a_default>;
spi-max-frequency = <2000000>;
interrupt-parent = <&gpio2>;
interrupts = <14 0>;
ti,enable-gpios = <&gpio2 2 GPIO_ACTIVE_HIGH>,
<&gpio2 5 GPIO_ACTIVE_HIGH>;
vin-supply = <&ldo3_reg>;
vdd-io-supply = <&ldo2_reg>;
autosuspend-delay = <30000>;
irq-status-read-quirk;
en2-rf-quirk;
clock-frequency = <27120000>;
};
};