| Devicetree bindings for Maxim DS2760 |
| ==================================== |
| |
| The ds2760 is a w1 slave device and must hence have its sub-node in DT |
| under a w1 bus master node. |
| |
| The device exposes a power supply, so the details described in |
| Documentation/devicetree/bindings/power/supply/power_supply.txt apply. |
| |
| Required properties: |
| - compatible: must be "maxim,ds2760" |
| |
| Optional properties: |
| - power-supplies: Refers to one or more power supplies connected to |
| this battery. |
| - maxim,pmod-enabled: This boolean property enables the DS2760 to enter |
| sleep mode when the DQ line goes low for greater |
| than 2 seconds and leave sleep Mode when the DQ |
| line goes high. |
| - maxim,cache-time-ms: Time im milliseconds to cache the data for. When |
| this time expires, the values are read again from |
| the hardware. Defaults to 1000. |
| - rated-capacity-microamp-hours: |
| The rated capacity of the battery, in mAh. |
| If not specified, the value stored in the |
| non-volatile chip memory is used. |
